|
|
|  | 
 
The Bogen BPA60 solid-state power amplifier has been designed to fulfill the power
amplification requirements of professional and commercial sound systems. The Model
BPA60 supplies 60 watts RMS output. Total harmonic distortion is less than 2%
at rated output from 50Hz to 5kHz.
Input impedances for the BPA60 are: high-impedance
(50k-ohms) unbalanced; and low-impedance (500/600 ohms, balanced or unbalanced)
with accessory transformer Model TL600. Line-bridging may be achieved with accessory
transformer Model TL100. Hum and noise are at least 85dB below rated output. The
BPA60 amplifier may be driven from an amplifier that provides a 25- or 70-volt
output.
Output imped-ances for the BPA60 are: 8-ohm/25V, 16-ohm, 25VCT and
70V. Output regulation is better than 2dB from no load to full load. The BPA60
amplifier is thermally protected to prevent damage due to excessive temperatures;
however, it will deliver the full rated output continuously, even at +130? F (+55?
C). Additional protection is provided by transient protection diodes and an electrical
circuit breaker. An illuminated on/off power switch is located on the front panel.
An input level control, circuit breaker reset, lo-cut filter switch, and auxiliary
receptacle are located on the rear panel. A rack panel kit (RPK53) is available
for mounting the amplifier in a 19-inch equipment rack.- 60 watts rated
power
- Distortion less than 2% THD
- Transient protection diodes
- Frequency response -2dB from 20Hz to 20kHz
- Multiple output voltages/impedances
available
- Resettable circuit breaker; thermally protected
- UL
and CSA listed
|
|
| |
